Roland XC-540 - How to Load Sheet Media

6-4 Accommodating Various Kinds of Media
90
Chapter 6 Feature Reference
How to Load Sheet Media
As with standard-size media, make sure of the following points when loading sheet media.
Procedure
➊
Remove both shafts.
If roll media is loaded, then remove the media first.
➋
Pass the media through the machine.
➌
Align the front edge of the media with the location shown
in the figure.
➍
Lower the loading lever to secure the media in place.
➎
If you're performing printing, attach the media clamps and close the front cover.
➏
Use to select "PIECE."
Press
.
Media
Align here
SETUP SHEET
PIECE