28
Chapter 2 Operation
2-1 Switching the Power On and Off
Switching the Power On and Off
This machine has a main power switch and a sub power switch. Switch on both to use the machine.
Whenever output is finished, switch off the sub power. Also, raise the loading lever.
Leave the main power switch
➀ on at all times, never switching it off. Leaving it on activates the alarm feature.
☞ P. 78, "Alarm Feature"
WARNING
When output is not being performed, remove any loaded media or switch off the
power.
The continued application of heat at a single location may cause the release of toxic gases
from the media or pose a fire hazard.
Turn this switch on after
closing the front cover. To turn
it off, hold down the switch for
one second or longer.
➁ Sub power switch➀ Main power switch
Flip the loading lever down
to the rear when not in use.
Rear of the printer Front of the printer
Be sure to leave
switched on at all times.
Important Note on Switching Off the Power
Never switch off the main power or unplug the power
cord suddenly while operation is in progress. Doing so
may damage the print heads. Be sure to first switch off
the sub power.
If the main power is accidentally switched off, immedi-
ately turn the power back on.
To Next Page
Loading...
