137
Chapter 7 What to Do If
7-7 If a Message Appears
These are the main messages that appear on the machine's
display to prompt correct operation. They do not indi-
cate any error. Follow the prompts and take action ac-
cordingly.
[1■ 2■ 3■ 4■ ...]
Only a small amount of ink remains. Replace the cartridge
indicated by the flashing number with a new cartridge.
[PRESS POWER KEY TO CLEAN]
This appears when the machine has been unused for about
one month.
This feature is to remind you to switch on the sub power
once a month.
☞ P. 78, "When Not in Use for a Prolonged Period"
[SET SOL CRT.]
Insert the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[REMOVE SOL CRT.]
Remove the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[SET SOLCL-LIQUID]
Insert the cleaning cartridge indicated by the flashing num-
ber. This message appears at times such as during head
cleaning.
[REMOVE SOLCL-LIQUID]
Remove the cleaning cartridge indicated by the flashing
number. This message appears at times such as during head
cleaning.
[SET CARTRIDGE.]
Insert the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[END OF THE SHEET]
The trailing edge of the media was detected during opera-
tion. Press any button on the operation panel to clear the
message. Load new media.
[SHEET NOT LOADED PRESS SETUP KEY]
Load media and press . This message appears when
an attempt to perform a printing test was made while no
media was loaded.
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain
bottle, then press
.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid
collects in the drain bottle. To clear the message, press
. If this screen appears, go to the [DRAIN BOTTLE]
menu and discard the discharged fluid in the bottle.
☞ P. 62, "Disposing of Discharged Ink"
[NOW HEATING...]
Wait until the media heating system reach the preset tem-
perature. Printing starts when
lights up.
You can stop printing by holding down
for one
second or longer while this is displayed. Pressing
makes printing start immediately, without waiting to reach
the preset temperature.
[CLOSE THE FRONT COVER]
Close the front cover.
For safety, the carriage does not operate while a cover is
open.
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height speci-
fied on the computer.
The heads move to a location where you can operate the
height-adjustment lever. Adjust to the displayed height, then
press
.
[REMOVE MEDIA CLAMPS]
This appears if is pressed while the media clamps
are attached. Remove the media clamp and press
.
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit. After
verifying, press
.
☞ P. 68, "Cleaning the Heads Using the Cleaning Kit"
[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press .
☞ P. 72, "Replacing the Wipers"
To Next Page
Loading...
