6-4 Accommodating Various Kinds of Media
86
Chapter 6 Feature Reference
Using Transparent Media
Procedure
➊
Press .
Press
several times .
➋
Press twice.
Use
to select "DISABLE."
Press
to enable the setting.
➌
The settings are changed and the screen shown in the figure appears.
Description
This setting enables or disables detection of the leading and trailing edges of the media. It is normally set to "ENABLE."
When transparent media is loaded, set it to "DISABLE." When this is set to "DISABLE," the "ROLL" and "TU" selections
are available during media setup. At this time, ensure a margin of at least 75 mm from the leading edge of the media
to the printing- or cutting-start location.
When [EDGE DETECTION] is set to "DISABLE," the machine cannot detect when media runs out. In such cases,
printing operation does not stop when the media runs out, and there is a chance that the platen or the like may
become soiled by ink or that ink may get inside and damage the machine. If media runs out while printing is in
progress, immediately press
to quit printing.
Default Setting
[EDGE DETECTION]: ENABLE
Printing Hard-to-dry Media
Procedure
➊
Press .
Press
several times.
➋
Press .
Press
.
➌
Press .
Use
to set the value.
Press
.
➍
Press .
Press
to go back to the original screen.
SETUP SHEET
ROLL
MENU
SUB MENU
MENU
SUB MENU
EDGE DETECTION
ENABLE
DISABLE
W 1346mm
SETUP SHEET
ROLL
SUB MENU
SCAN INTERVAL
SCAN INTERVAL
OFF
1.0 sec
To Next Page
Loading...
