6-5 Setting How the Printer Operates
96
Chapter 6 Feature Reference
Description
Setting this to "ENABLE" automatically displays [SHEET REMAIN] whenever you change the media and finish setup.
This makes it impossible to go on to the next operation unless you redo the setting for the amount remaining. This can
be useful for keeping you from forgetting to redo the setting when you change the media.
When you set this to "ENABLE," however, be sure also to set the [EDGE DETECTION] menu item to "ENABLE." When
[EDGE DETECTION] is set to "DISABLE," then [SHEET REMAIN] is not displayed automatically, regardless of the
setting for [AUTO DISPLAY].
Also, when sheet media is loaded (that is, when [SETUP SHEET] is set to "PIECE"), the setting for the amount of
remaining media is made automatically, and so this menu is not displayed.
☞ P. 86, "Using Transparent Media"
Default Setting
[AUTO DISPLAY]: DISABLE
Printing the Amount of Remaining Media
Procedure
➊
Press .
Press
twice.
➋
Press .
Press
to perform printing.
➌
Press .
Press
to go back to the original screen.
Description
This prints the amount of media remaining that is displayed at the top menu. You use this when you want to make a
record of the remaining length of the media now in use. Printing the amount of media remaining before you change
the media enables you to refer to the printed record and use the value to make the setting for the remaining amount the
next time you use the media.
Returning All Settings to Their Initial Values
Procedure
➊
Press .
Press
several times.
➋
Press .
Press
several times.
Press
to execute.
Description
This menu returns all settings to the same as their factory defaults. However, the settings for [LANGUAGE], [LENGTH
UNIT], and [TEMP. UNIT] are not returned to the factory defaults.
SHHET REMAIN
PRINT MEMO
W 1346mm
SETUP SHEET
ROLL
MENU
SHEET REMAIN
MENU
SUB MENU
SUB MENU
FACTORY DEFAULT
To Next Page
Loading...
Need help?
General
