Roland XC-540 - Making Various Adjustments for Cutting; Performing Distance Correction During Cutting

97
Chapter 6 Feature Reference
6-6 Making Various Adjustments for Cutting
Performing Distance Correction During Cutting
Procedure
➊
Press .
Press
.
➋
Press .
Press
twice.
➌
Press twice.
Use
to make the setting for the correction value.
Press
to enable the setting for [FEED SETTING].
➍
Press .
Press
.
➎
Press .
Use
to make the setting for the correction value.
Press
to enable the setting for [SCAN SETTING].
➏
Press .
Press
to go back to the original screen.
Description
The movement distance for the media changes subtly depending on the media's thickness. This means that the length
of a line when cut may differ from the length setting in the data. You enter a correction value when you want to align
the lengths of cut lines precisely.
When performing printing followed immediately by cutting, be sure to set this to "0.00."
Default Setting
[FEED SETTING]: 0.00%
[SCAN SETTING]: 0.00%
CUTTING MENU
CALIBRATION
MENU
CUTTING MENU
FEED SETTING
0.00%
0.00%
CALIBRATION
SCAN SETTING
SCAN SETTING
0.00%
0.00%
W 1346mm
SETUP SHEET
ROLL