Roland XC-540 - Using the Take-Up System; How to Take up Media

57
Chapter 4 Operation of the Media Take-up System
4-2 Using the Take-up System
How to Take Up Media
1. Pass the media through the printer.
➊
Move the dancer roller toward the rear.
➋
Load the roll media.
☞ P. 30, "How to Load Media"
➌
Pull back the loading lever to secure the media in place.
2. Fasten the media to the paper tube.
For information on how to attach the paper tube, refer to the Setup Guide.
➊
Use to select "TU."
Press
.
➋
Press to adjust the length of the media to be pulled out.
You can adjust the length of the media in 10-millimeter steps by pressing .
(To pull out media continuously, hold down the key. )
Dancer roller
Loading lever
SETUP SHEET
TU
LOAD SHEET
TO TAKE-UP