Roland XC-540 - 6-8 Media Heating System Operation Settings

6-7 Correcting Misalignment for Printing or Cutting
108
Chapter 6 Feature Preference
5. From the test pattern, read the correction value at the location.
6. Enter the correction value you read.
➊
Press .
➋
Press .
Press
.
Use
to set the adjustment value for [FEED SETTING].
Use
to set the adjustment value for [SCAN SETTING].
Press
to enable the setting.
➌
Press .
7. Check the results of adjustment.
Press .
Press
to execute.
If the printing and cutting lines are aligned, adjustment is complete.
If further adjustment is needed, go back to step
6. and fine-tune the adjust-
ment.
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
CROP - CUT ADJ.
SETTING
CROP - CUT ADJ.
TEST PRINT
CROP - CUT ADJ.
SETTING
-0.5
+2.0 -2.0
-1.0
+0.5 -0.5
+0.0 -0.0
+1.5 -1.5
+2.0
-2.0
+1.0
-1.0
+0.5
-0.5
+0.0
-0.0
+1.5
-1.5
FEED
SCAN
Cutting line
Test pattern
Correction-value scale
Check the value on
the [SCAN] side.
Check the value on
the [FEED] side.
Scan direction
The point where the cutting line
intersects the correction-value
scale is the correction value. In this
figure, the value is "-0.3." Use the
same method to read the value on
the [FEED] side.
Cutting line
Cutting position and print-
ing position are aligned.
Printing position
Cutting position