8-3 Specifications
149
Chapter 8 Appendix
*1
The length of printing or cutting is subject to the limitations of the program or driver.
*2
➢ With Roland PET film, print travel: 1 m
➢ Temperature: 25°C (77°F), humidity: 50%
*3
Not assured when the print heater or dryer is used.
*4
The following conditions must be met:
➢ Media type: Media specified by Roland DG Corp.
➢ Roll media must be loaded on the shaft.
➢ [PREFEED] menu item must be set to "ENABLE."
➢ Side margins: 25 mm or more for both the left and right margins
➢ Front margin: 35 mm or more
➢ Excluding expansion/contraction of the media
Range for assured repetition accuracy
➢ For media with a width exceeding 610 mm: Length 4,000 mm
➢ For media with a width of 610 mm or less: Length 8,000 mm
*5
➢ Provided that media length is under 3,000 mm
➢ Temperature: 25°C (77°F)
➢ Excluding possible shift caused by expansion/contraction of the media and/or by reloading the media.
*6
➢ Media type : Roland PET film
➢ Data size: 1,000 mm in the media-feed direction, 1,346 mm in the carriage-movement direction.
➢ No lamination
➢ Automatic detection of crop marks at 4 points when media is reloaded.
➢ During cutting, [PREFEED] menu item must be set to "ENABLE."
➢ Temperature: 25°C (77°F)
➢ Excludes the effects of slanted movement and of expansion and contraction of the media.
*7
➢ Warm-up is required after powerup. This may require 5 to 20 minutes, depending on the operating environment.
➢ Depending on the ambient temperature and media width, the preset temperature may fail to be reached.
*8
Operating environment
80
55
35
15 27 32
Humidity
20
(%)
°C (°F)
(no condensation)
Temperature
(
59
)(
89.6
)(
80.6
)(
68
)
0
Use in an operating environment
within this range.
To Next Page
Loading...
