3-3 Cutting Using the Crop-mark Feature
50
Chapter 3 Using the Cutting Feature
Media Sizes Allowing Automatic Crop Mark Detection When Reloading the Media
When you're cutting off media printed with crop marks, reloading it, and performing automatic crop-mark detection,
set a margin of at least 90 millimeters before the next print-start position. For other margins, refer to the figure below.
You can set the margin value with the software RIP you're using. For information on how to make the setting, refer to
the documentation for the software RIP you're using.
90 mm (3-9/16 in.)
or more
Pinch rollers
Where to cut the media off
Crop marks
80 mm (3-3/16 in.) or more
1.5 mm (about 0.06 in.) 1.5 mm (about 0.06 in.)
The actual size where
output is possible
22.5 mm (0.89 in.)
22.5 mm (0.89 in.)
To Next Page
Loading...
