Roland XC-540 - Page 73

5-3 Cleaning the Heads Using the Cleaning Kit
71
Chapter 5 Maintenance and Adjustment
3. Quit the manual cleaning mode.
➊
Close the front cover.
Press
.
The print-head carriage moves to the right side of the machine, and then the
screen shown in the figure appears.
➋
Open the front cover and close the maintenance cover.
➌
Close the front cover.
Press
.
➍
Press .
Press
to go back to the original screen.
4. Perform a printing test to verify the results of the procedure.
Perform a printing test to check the results.
Perform cleaning several times as required.
☞ P. 40, "Printing Tests and Cleaning"
W 1346mm
SETUP SHEET
ROLL
Maintenance cover
MAINTENANCE
CLEANING
CLEANING...
CLOSE MAINTE-
NANCE COVER