Roland XC-540 - Page 75

5-4 Replacing Consumable Parts
73
Chapter 5 Maintenance and Adjustment
2. Replace the wipers. Use the included tweezers.
➊
Detach the old wipers.
Detach the hook and pull up and out.
➋
Insert the new wipers.
➌
Attach the hook.
3. Quit the [REPLACE WIPER] menu.
➊
Close the front door.
Press
.
After the process to quit the [REPLACE WIPER] menu ends, the screen shown in
the figure appears.
➋
Press .
Press
to go back to the original screen.
➌
Perform a printing test to verify the results of the procedure.
☞ P. 40, "Printing Tests and Cleaning"
Felt surface toward
the rear
Rubber surface toward
the front
Hook
MAINTENANCE
REPLACE WIPER
CLEANING...
W 1346mm
SETUP SHEET
ROLL