Operation
Edition BE210202
03.2022
Rondostar 5000
Operating manual
95
5.10.2 Inserting the cutting rollers
Danger of injury on the sharp cutting edges of the cutting roll-
ers!
The cutting rollers must be inserted in the running direction of the
dough in the following sequence:
a) For rectangles / squares
First cut lengthwise, then crosswise.
In order to ensure trouble-free working with the cross cutting roller, it
must be inserted into the cutting station in such a way that the dough
band is first cut with the cutting knife (2) and then ejected by the ejector
(1).
b) For triangles
First use zig-zag cutting, then length cutting.
Cutting rollers not being used must be stored in the repository
provided for this purpose.
Reason: This will prevent damage to the cutting knives. Injury to
the operator will also be prevented.
37
1
2
37
To Next Page
Loading...
