Rondo Rondostar 5000 Basic - Cutting

Operation
Edition BE210202
03.2022
Rondostar 5000
Operating manual
97
5.10.5 Cutting
• The “Dough cutting” program step must be added to the program
as an end function.
• Immediately before cutting, the width of the dough band must
correspond to the length of the cutting roller to be used plus
approx. 1–2 cm on both sides.
• The roller gap must be sufficiently open while cutting. This pre-
vents the dough from jamming. The roller gap can be influenced
by the foreman or higher during the cutting and transferring
processes using parameter PC211.
1. Insert the cutters.
(See chapter 5.10.2 Inserting the cutting rollers).
2. Create and/or manage program.
3. Position the dough.
4. Press the black mushroom button on the dough side.
► Machine starts.
► Program is processed.
► “Lower cutting roller” pop-up opens.
5. Press the black mushroom button on the dough side.
► Machine starts.
6. Lower cutting roller at the right moment.
(See chapter 5.10.3 Lowering the cutting rollers)
► Dough is cut.