Roth EnergyLogic Touchline/wireless - Delete Assignment of a Radio Channel or Several Radio Channels to a Zone

User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
60 P100011294 E
Build third zone
► Press push button Zone at the wireless connection module briefly.
► The yellow LED indicating the third zone and the CH LEDs for channels not
yet assigned to a zone blink.
► Press the CH buttons for the radio channels that need to be assigned to
the third zone.
► The LEDs of the assigned channels light.
End zone building
► Press push button Zone at the wireless connection module briefly.
► The LEDs for zoning go off. The green Power LED lights.
The wireless connection is in operation. Zones are built.
7.2.2 Delete assignment of a radio channel or several radio channels to a
zone
Delete the assignment of a radio channel to a zone in reverse order compared
to the addressing
► Press the Zone button of the wireless connection module repeatedly until
the LED for the zone from which the radio channel must be deleted lights.
– Zone 1: blue LED
– Zone 2: red LED
– Zone 3: yellow LED.
► The CH LEDs that are assigned to the selected zone light.
► Press the CH button of the radio channel that needs to be deleted from the
zone.
► The relevant LED blinks. The radio channel is no longer assigned to the
zone.
► Repeat this procedure in case further or all assignments need to be delet-
ed.
NOTE
When all CH LEDs blink after the first press of the Zone button, then no
zones are built.