Roth EnergyLogic Touchline/wireless - General Parameters

User Manual Roth EnergyLogic Touchline/Wireless
Parameter descriptions
82 P100011294 E
9.3.3 P-20 "General parameters"
For the following parameter descriptions the relevant parameter was already
selected. The display shows P-xx.
Parameter Description
P-21 Show software-version of wireless room thermostat.
Operation
► Press sensor button
. The display shows the Software-Version.
► Press sensor button . The display shows P-22.
P-22 Show software-version of wireless connection module
Operation
► Press sensor button
. The display shows the Software-Version.
► Press sensor button
. The display shows P-23.
P-23 Show actual status of wireless connection module and I/O-Box.
● Options
– 0: no errors detected.
– 1: Alarm wireless connection module, TB-input active
– 2: Alarm external signal I/O-Box
– 3: Error wireless connection module and I/O-Box
Operation
► Press sensor button . The display shows 0 if no error is detected. If an error is
detected, then 1, 2 or 3 and the warning symbol
are shown.
► Press sensor button
. The display shows P-24.