User Manual Roth EnergyLogic Touchline/Wireless
Commissioning and operation
70 P100011294 E
Time program Pro2
► Select one of the following options:
– Press sensor button
, to skip time program Pro2 and to go to time
program Pro3.
– Press sensor button
, to leave the time program Pro2. The display
shows P-04.
– Press sensor button
, to configure time program Pro2.
► After pressing the sensor button
, the display shows the symbol for
working days
1
2
3
4
5
.
► Set all switching points of the desired switched-on periods for the working
days as described for Pro1.
► Repeat this procedure for the weekend. The display shows the symbol for
the weekend
6
7
.
Time program Pro2 has be set.
Time program Pro3
► Procedure as described for time program Pro 2.
With time program Pro3 all switching points of the desired switched-on peri-
ods are set per individual day of the week.
NOTE
To remove a switched-on period set the time of both switching points at the
same value. First remove the third switched-on period, then the second
switched-on period. When the second of three switched-on periods is re-
moved, then also the third is deleted.
Please note that if sensor buttons are not pressed for more than one mi-
nute the wireless room thermostat return to its battery saving mode before
the time program is completed.
7.6.5 Reset time programs to factory settings
The three time programs can be reset to factory settings individually with
parameter P-05.
To Next Page
Loading...
