Roth EnergyLogic Touchline/wireless - Page 83

User Manual Roth EnergyLogic Touchline/Wireless
Parameter descriptions
P100011294 E 83
Parameter Description
P-24 Reset parameter to factory settings.
Parameters are partly stored in the wireless connection module and partly in the
wireless room thermostat.
● Options
– 0: Not active, no reset will be executed.
– 1: Reset wireless connection module to factory settings. The addressing of
wireless room thermostat and wireless connection module will not be delet-
ed.
– 2: Reset wireless connection module to factory settings. The addressing of
wireless room thermostats, wireless connection module and accessories will
be deleted.
– 3: Reset wireless room thermostat to factory settings. The addressing of a
wireless room thermostat or temperature sensor (sensor mode) will not be
deleted.
– 4: Reset wireless room thermostat to factory settings. The addressing of
wireless room thermostat or temperature sensor (sensor mode) will be delet-
ed.
Operation
► Press sensor button
. The display shows 0.
► Press sensor button
or , to select an option.
► Press sensor button
. The display shows no.
► Press sensor button or , to select between options no or yes.
► Select one of the following options:
– Press sensor button , to save the changed settings. The display shows the
next parameter P-21.
– Press sensor button , to interrupt the procedure. The display shows the se-
lected parameter.
Table 16: Service menu – P-20 "General parameter"