Fig. 18 - Parking brake assembly; (A- BRAKES DISK).
Bleeding air from the brake hydraulic system
Operate as follows:
— unhook pedals by removing the coupling latch: afterwards
place the "SEPARATE BRAKES" valve control in OFF posi-
tion;
— operate the right-hand brake pedal several times;
— by holding the pedal in fully depressed position, slightly un-
screw and tighten soon after the relevant air bleeding valve on
the rear right-hand brake.
This operation should be repeated until such time as the oil flows
out of the bleeding valve without air bubbles.
Repeat the same procedure on the front right-hand brake by acting
on the related air bleeding valve.
Follow the same procedure on the front and rear left-hand brakes
making use of the related air bleeding valves.
Fig. 19 - Bleeding the air from the front service
brake hydraulic system.
Fig. 20 - Bleeding the air from the rear service
brake hydraulic system.
vehicle
brakes
Use only AKROS MATIC fluid (international specification
ATF DEXRON II) in the brake control circuit.
electro-hydraulic version mechanical controls version
54
5
221
www.maskinisten.net
www.classicmachinery.net
To Next Page
Loading...
