Samsung DCS-816 - Page 150

SAMSUNG Programming
DCS-816 February, 1999
MMC 603 (Page 1 of 2)
MMC: 603 ASSIGN TRUNK GROUP
DESCRIPTION:
Allows the assignment of trunks to a specific trunk group or to several trunk
groups. This is very useful in the programming of LCR when more than one trunk
is to be in several dialling plans. There are two different modes of operation: (1)
sequential and (2) distribute.
WARNING
One trunk can appear in more than one trunk group. If necessary, delete the trunk member from
other groups to prevent accidental access.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ANS/RLS Used to select ALL
ACTION DISPLAY
1. Press TRSF 603
Display shows
[9] TRK GROUP
MODE:SEQUENTIAL
2. Enter in valid trunk group (e.g., 9, 80–82)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to advance cursor
[81] TRK GROUP
MODE:SEQUENTIAL
3. Press RIGHT soft key to change mode
OR
Press UP or DOWN key to change mode to
member
[81] TRK GROUP
MEMBER 01:NONE
4. Press RIGHT soft key to move cursor to number
of member and enter valid member number (01–
10, e.g., 05) via dial keypad
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to move cursor
[81] TRK GROUP
MEMBER 05:NONE
5. Enter valid trunk number (e.g., 705)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to return to step 2
[81] TRK GROUP
MEMBER 01:705
6. Repeat steps 1–5 to remove trunk from group 0 if
necessary