Samsung DCS-816 - Program Trunk Names

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 4
COUNT>
1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y Z 9
DIAL Q : = [ ]
Q
The # key can be used for the following special characters: #, space, &, !, :, ?, ., %, $, -, /,
=, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
3.5 PROGRAM TRUNK NAMES
This program is used to assign a name or identification to each C.O. line. You may assign
a name up to 11 characters long.
PROGRAM KEYS
UP & DOWN Used to scroll and move cursor.
KEYPAD Used to enter characters.
HOLD Press to clear entry.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 404 [701] TRUNK NAME
2.
Dial trunk (e.g., 704)
OR press UP or DOWN to select trunk and press the
[704] TRUNK NAME
right soft key to move the cursor
3. Enter the trunk name using the procedure in Program
Station Names (above) and press the right soft key to
[704] TRUNK NAME
SAMSUNG
return to step 2
4.
Press TRSF to store and exit programming
OR press SPK to store and advance to the next
program