SAMSUNG Programming
DCS-816 February, 1999
2-12
CALLING LINE INDICATION PRESENTATION
(CLIP)
Hardware Provisions
ISDN trunk cards
Software Provisions
The MMCs related to CLIP are listed below with a short description of their use. They
are listed in the recommended order in which they should be programmed. This
sequence is suggested so that the installer gets a better understanding of how the
feature works. There is no technical reason to follow this sequence.
l
MMC 312 ALLOW CLIP This MMC is used by the technician to
determine which keysets are allowed to
receive CLIP displays.
l
MMCs 722 and 723 These MMCs have had new keys related
to CLIP features added to them. It is
strongly recommended that all keysets
allowed CLIP in MMC 312 are
programmed with a CLIP key.
l
MMC 728 CLIP TRANSLATION This MMC allows the technician to create
a list of names that correspond to
numbers received from the Central Office
(C.O.). These names will be displayed
when a call rings in that has NUMBER
ONLY data provided by the C.O.
l
MMC 725 SMDR OPTIONS The ability to print CLIP data and
abandoned calls has been added to this
MMC.
l
MMC 119 CLIP DISPLAY This MMC is used by the end user to
determine which piece of CLIP data is
To Next Page
Loading...
