Samsung DCS-816 - MMC: 200 OPEN CUSTOMER PROGRAMMING

SAMSUNG Programming
DCS-816 February, 1999
MMC 200 (Page 1 of 1)
MMC: 200 OPEN CUSTOMER PROGRAMMING
DESCRIPTION:
Used to open (enable) and close (disable) customer–level programming. If
programming is not opened and an attempt is made to access a system MMC,
the error message [NOT PERMIT] will be displayed. A four-digit passcode is
required to access this MMC. Each digit can be 0–9. When opened, this MMC
enables access to all MMCs allowed in MMC 802, Customer Access MMC
Number.
PROGRAM KEYS
UP & DOWN Select open or closed
KEYPAD Used to enter passcode
SPK Save data and advance to next MMC
TRSF Exit programming
ACTION DISPLAY
1. Press TRSF 200
Display shows
ENABLE CUS.PROG.
PASSCODE:
2. Enter passcode
ENABLE CUS.PROG.
PASSCODE:
Correct code shows
ENABLE CUS.PROG.
DISABLE
Incorrect code shows
ENABLE CUS.PROG.
PASSWORD ERROR
3. Press UP or DOWN arrow key to select
ENABLE or DISABLE and press RIGHT soft
key
OR Dial 1 for ENABLE or 0 for DISABLE
ENABLE CUS.PROG.
ENABLE
4. Press SPK to advance to MMC entry level and
press UP or DOWN key to select MMC
(e.g 212)
OR
212:ALARM RING
SELECT PROG. ID
Enter MMC number and press RIGHT soft
key to enter MMC
5. Press TRSF key to exit
DEFAULT DATA: Closed (Disabled)
RELATED ITEMS: MMC 201 Change Customer Passcode
MMC 501 System–Wide Timers
MMC 802 Customer Access MMC Number