Samsung DCS-816 - Create Programmed Station Messages; Message

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 10
3. If the selected station has no speed dial bins, this
display will be shown and a new station may be
[205] SPEED DIAL
SPDBLK NOT EXIST
selected
4.
Dial the speed dial location (e.g., 05)
OR use UP or DOWN to scroll through the location
[205] SPEED NAME
01 : _
numbers and use the right soft key to move the cursor
OR press the left soft key to return to step 2
5. Enter the name using the procedure in Program
Station Names (above) and press the right soft key to
[205] SPEED NAME
01 : SAM SMITH
return to step 2
OR press the left soft key to return to step 3
6.
Press the F key to access Program Personal Speed
Dial Numbers For Other Stations (above)
OR press TRSF to store and exit programming
OR press SPK to store and advance to the next
program
3.11 CREATE PROGRAMMED STATION MESSAGES
Messages 1-10 are programmed from the factory and cannot be changed. However, you
can create 10 additional 16-character messages (11-20) that fit your company's needs.
After programming these messages, inform other employees so they can add the new
messages to the list on the back of their user guides.
PROGRAM KEYS
UP & DOWN Select the message number.
KEYPAD Used to enter characters.
HOLD Press to clear entry.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 715 PGM MESSAGE (01)
IN A MEETING
2.
Dial in the message number (e.g., 11)
OR press UP or DOWN to make the selection and
MGM MESSAGE (11)
_
press the right soft key to move the cursor
3. Enter in the message using the procedure in Program
Station Names (above) and press the right soft key to
PGM MESSAGE (11)
IN THE SHOWROOM
return to step 2 above