Samsung DCS-816 - Program Station Group Names

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 5
3.6 PROGRAM STATION GROUP NAMES
This program is used to assign a name or identification to each station group (501-504).
You may assign a name up to 11 characters long.
PROGRAM KEYS
UP & DOWN Used to scroll and move cursor.
KEYPAD Used to enter characters.
HOLD Press to clear entry.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 602 [500] SGR NAME
2.
Dial the group number (e.g., 504)
OR press the UP or DOWN key to make a selection
[504] SGR NAME
and press the left or right soft key to move the cursor
3. Enter the name using the procedure in Program
Station Names (above)
[504] SGR NAME
SAMSUNG
4. Press the left or right soft key to return to step 2
OR press TRSF to store and exit programming
OR press SPK to store and advance to the next
program