Samsung DCS-816 - Part 3. System Administrator Programming; Customer-Level Access; Set Date and Time Display

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 1
PART 3. SYSTEM ADMINISTRATOR PROGRAMMING
3.1 CUSTOMER-LEVEL ACCESS
Before any customer programs can be accessed, you must first open system
programming using the passcode you have been assigned. This must be done using an
LCD 24B keyset. Should it become necessary to change this passcode, ask your
installation and service company.
• While your handset is on-hook, press TRSF and then dial 200.
• The display shows [ENABLE CUS. PROG. PASSCODE].
• Dial the four-digit passcode.
• The display shows [ENABLE CUS. PROG. - DISABLE].
• Dial 1 to enable.
• The display shows [ENABLE CUS. PROG - ENABLE].
• Press TRSF. The keyset returns to its idle condition.
• Now press TRSF and the three-digit program code you want to access. Follow the
instructions for that program.
NOTE: You must begin programming within 30 seconds. Once you start programming,
any delay of more than 30 seconds between key strokes will cause the system to
automatically close programming.
3.2 SET DATE AND TIME DISPLAY
Should it ever become necessary to correct the date and time displayed on all of the
keysets, do so as soon as you notice that they are incorrect. Automatic Night Service will
not work correctly and SMDR records will be of no value if the date and time are not
correct.
The display format is as follows:
W Day of the week, 0-6
enter 0 for Sunday and 6 for Saturday
MM Month, 01-12
enter 01 for January and 12 for December
DD Day of the month
enter a number in the range 01-31.
YY Year enter the last two digits of the year, e.g. 98.
HH Hours use the 24-hour clock and enter a number in the
range 00-24.
MM Minutes enter a number in the range 00-59.
Failure to enter the time using the 24-hour clock will cause the date to change at 12:00
P.M. Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 505
Display shows
OLD: 1060198:1220
NEW: MMDDYY:HHMM
2. Enter new time and date using above table
OLD: 1060198:1220
NEW: 2070798:1545