Samsung DCS-816 - Program Station Names

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 3
3.4 PROGRAM STATION NAMES
This program is used to assign a name or identification to each extension. You may
assign a name up to 11 characters long.
PROGRAM KEYS
UP & DOWN Used to scroll and move cursor.
KEYPAD Used to enter characters.
HOLD Press to clear entry.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 104 [201] STN NAME
2.
Dial station number (e.g., 205)
OR press UP or DOWN to select the station and press
[205] STN NAME
the right soft key to move the cursor
3. Enter the station name using the procedure described
below and press the right soft key to return
[205] STN NAME
SAM SMITH
to step 2
4.
Press TRSF to store and exit programming
OR press SPK to store and advance to the next
program
NOTE: Directory information is always 11 characters.
DEFAULT DATA: None
Names are written using the keypad. Each press of a key selects a character. Pressing
the dial pad key moves the cursor to the next position. For example: if the directory name
is "SAM SMITH," press the number "7" four times to get the letter "S". Now press the
number "2" twice to get the letter "A". Continue selecting characters from the table below
to complete your message. Pressing the "A" key changes the letter from upper case to
lower case.
NOTE: When the character you want appears on the same dial pad key as the previous
character, press the UP key to move the cursor to the right.