SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 2
3. Verify time and date
Reenter if necessary
OLD: 2070798:1545
NEW: MMDDYY:HHMM
4. Press the right soft key to return to step 2
OR press TRSF to store and exit programming
OR press SPK to store and advance to the next
program.
If you have entered invalid data, you will receive an [INVALID ENTRY] message for three
seconds. Reenter the correct date and time. If the information you entered is incorrect,
repeat the procedure.
3.3 RESET STATION PASSCODES TO DEFAULT
Individual keyset users can set or change their own individual passcodes. These
passcodes are used to lock and unlock keysets, override toll restriction (call barring) and
access the DISA feature. At times, it may be necessary for the system administrator to
reset a station's passcode to default "1234". This program is used only to reset the
passcodes and cannot be used to display them.
PROGRAM KEYS
UP & DOWN Select the extension number.
HOLD Press to reset the passcode.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 101 [201] PASSCODE
PASSCODE: QQQQ
2.
Dial the station number (e.g., 205)
OR use the UP and DOWN keys to scroll through the
[205] PASSCODE
PASSCODE: QQQQ
keyset numbers and press the right soft key to move
the cursor right
3.
Press HOLD to reset passcode [205] PASSCODE
PASSCODE: 1234
4. Press the right soft key to return to step 2
OR press TRSF to store and exit programming
OR press SPK to store and advance to the next
program
DEFAULT DATA: ALL STATION PASSCODES = 1234
To Next Page
Loading...
