SAMSUNG Programming
DCS-816 February, 1999
MMC 104 (Page 1 of 2)
MMC: 104 STATION NAME
DESCRIPTION:
Allows the system administrator or technician to enter a name (up to 11
characters) to identify an individual station.
Names are written using the keypad. Each key press selects a character.
Pressing the dial pad key moves the cursor to the next position. For example, if
the directory name is “ SAM SMITH,” press the number “ 7” four times to get the
letter “ S.” Now press the number “ 2” once to get the letter “A.” Continue selecting
characters from the table below to complete the name. Pressing the bottom left
programmable key will change the letter from upper case to lower case.
NOTE
When the character you want appears on the same dial pad key as the previous character,
press the UP key to move the cursor to the right.
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y Z 9
DIAL Q : = [ ]
Q
The # key can be used for the following special characters: #, space,
&, !, :, ?, ., ,, %, $, –, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;,", →,` , and \.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
A Key 19; acts as toggle between upper case and lower case
ACTION DISPLAY
1. Press TRSF 104
Display shows
[201] STN NAME
2. Dial station number (e.g., 205)
OR
[205] STN NAME
_
Press UP or DOWN to select station and
press RIGHT soft key to move cursor
To Next Page
Loading...
