Samsung DCS-816 - Program System Speed Dial Numbers

SAMSUNG System Administration and Special Features Guide
DCS-816 February, 1999
3 - 6
3.7 PROGRAM SYSTEM SPEED DIAL NUMBERS
The system list starts with 200 numbers and can be increased in blocks of 10. The
maximum amount is 300 numbers if no more than 200 station speed dial numbers are
assigned. Ask your service company to increase or decrease the system list.
Speed dial codes are 500-799. Each speed dial number consists of a line access code
and the telephone number to be dialled. The access code can be any line group,
individual line, station group or individual extension. The speed dial number can be up to
24 characters long including #, FLASH and PAUSE.
NOTE: If Least Cost Routing (LCR) is being used, the LCR access code must be entered.
When you are entering a speed dial number, there are some special keys that you will
need to use. These are the last 6 programmable keys of the righthand row known as A, B,
C, D, E and F and are defined below.
PROGRAM KEYS
UP & DOWN Select the speed dial bin.
KEYPAD Used to enter number.
HOLD Press to clear entry.
SPK/RLS Save data and advance to next program.
A Does not have a function.
B Inserts a FLASH.
C Inserts a PAUSE.
D Changes the dialling type from pulse to tone.
E Hides and displays digits.
Open customer programming and follow the instructions below.
OPERATION
1.
Press TRSF 705 SYS SPEED DIAL
500:
2.
Dial the speed bin desired (e.g., 505)
OR press UP or DOWN to make the selection and
SYS SPEED DIAL
505:
press the right soft key to move the cursor
3. Enter the access code (e.g., 0 - the system
automatically inserts a dash) followed by the phone
SYS SPEED DIAL
505:0-121223456789
number (up to 18 digits long) and press the right soft
key to return to step 2
4.
Press the F key to toggle to Program System Speed
Dial Names, step 3 (below) to enter the name
SYS SPEED NAME
505: