SAMSUNG Programming
DCS-816 February, 1999
2-2
711: LCR TIME TABLE 733:
AA PLAN TABLE
712: LCR ROUTE TABLE 734:
AA MESSAGE MATCH
713: LCR MODIFY DIGIT TABLE 735:
AA USE TABLE
714: DID NUMBER & NAME TRANSLATION 736:
ASSIGN AA MOH
715: PROGRAMMED STATION MESSAGE 740: STATION PAIR
716: UK LCR OPTION 800: ENABLE TECHNICIAN PROGRAM
718: MY AREA CODE 801: CHANGE TECHNICIAN PASSCODE
720: COPY KEY PROGRAMMING 802: CUSTOMER ACCESS MMC NUMBER
721: SAVE STATION KEY PROGRAMMING 804: SYSTEM I/O PARAMETER
722: STATION KEY PROGRAMMING 805: TX LEVEL & GAIN
723: SYSTEM KEY PROGRAMMING 806: CARD PRE–INSTALL
724: DIAL NUMBERING PLAN 807: VOLUME CONTROL
725: SMDR OPTIONS 809: SYSTEM MMC LANGUAGE
726: VM/AA OPTIONS 810: HALT PROCESSING
727: SYSTEM VERSION DISPLAY 811: RESET SYSTEM
728: CLIP TRANSLATION TABLE 812: COUNTRY CODE
730: AA RECORD GAIN
731: AA RAM CLEAR
732: AA TRANS TABLE
2.2 PROGRAM PROCEDURES
The instructions for each MMC assume that you have already opened
programming. First, run MMC 812, Country Code, to set your country (e.g UK)
before you do any other programming.
CAUTION
This manual describes standard settings. Some MMC codes and default data may be different from
those shown depending on the country selected in MMC 812.
Helpful hint:
When you are finished programming in MMC codes 100–812 and have other
programming to do, press SPK to exit the MMC but stay in the programming
mode and use one of the following methods.
1. Dial another MMC code directly and continue programming.
2. Press VOLUME UP and DOWN keys to scroll through all MMC codes. When
the desired MMC code is reached, press SPK and continue programming.
Pressing TRSF will always save changes and exit programming mode.
To Next Page
Loading...
