SAMSUNG Programming
DCS-816 February, 1999
MMC 705 (Page 1 of 2)
MMC: 705 ASSIGN SYSTEM SPEED DIAL
DESCRIPTION:
Enables the assignment of system speed dialling numbers. There are 500 entries
available for programming (see MMC 606). Each speed dial number consists of a
trunk or trunk group access code followed by a separator and up to 24 digits to be
dialled. These dialled digits may consist of 0–9, Q and #. If the system recognises a
valid trunk or trunk group access number, it will automatically insert the separator.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
B Used to insert a flash code "F"
C Used to insert a pause code "P"
D Used to insert a pulse/tone conversion code "C"
E Used to mask/unmask following digits – shows as "["or "]"
F Used to enter name for speed dial bin (see MMC 706)
ACTION DISPLAY
1. Press TRSF 705
Display shows
SYS SPEED DIAL
500:
2. Dial speed index desired (e.g., 505)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key to move cursor
SYS SPEED DIAL
505:
3. Enter access code (e.g., 9/701) plus the phone
number up to 24 digits (digits will scroll under)
and press RIGHT soft key to return to step 2
SYS SPEED DIAL
505:9–121223456
4. Press F key to toggle to MMC 706 step 3 to
enter name
SYS SPEED NAME
505:
5. Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
DEFAULT DATA: None
RELATED ITEMS: MMC 606 Assign Speed Block
MMC 706 System Speed Dial By Name
“A” button is button #19 on keyset
“B” button is button #20 on keyset
To Next Page
Loading...
