Samsung DCS-816 - Page 185

SAMSUNG Programming
DCS-816 February, 1999
MMC 715 (Page 1 of 2)
MMC: 715 PROGRAMMED STATION MESSAGE
DESCRIPTION:
Allows a 16–character (max.) custom message to be programmed. Messages are
written via the keypad. Each press of a key selects a character. Pressing a different
key moves the cursor to the next position. For example, if the message is
“ Sunbathing,” press the number “ 7” four times to get the letter “ S.” Now press the
number “ 8” twice to get the letter “ U.” Continue selecting characters from the table
below to complete your message. Pressing the “ A” key changes the letter from
upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as the
previous character, press the UP key to move the cursor to the right or the DOWN
key to move the cursor to the left.
COUNT 1 2 3 4 5
DIAL 0
< > . ) 0
DIAL 1
Space ? , ! 1
DIAL 2
A B C @ 2
DIAL 3
D E F # 3
DIAL 4
G H I $ 4
DIAL 5
J K L % 5
DIAL 6
M N O ^ 6
DIAL 7
P Q R S 7
DIAL 8
T U V
Q
8
DIAL 9
W X Y Z 9
DIAL
Q : = [ ]
Q
The # key can be used for the following special characters: #, space, &, !, :, ?, ., %,
$, –, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
“ A” KEY Toggles from upper case to lower case
ACTION DISPLAY
1. Press TRSF 715
Display shows
PGM.MESSAGE(01)
IN A MEETING
2. Enter index number (e.g., 11)
OR
PGM.MESSAGE(11)
EMPTY MESSAGE