SAMSUNG Programming
DCS-816 February, 1999
MMC 723 (Page 1 of 3)
MMC: 723 SYSTEM KEY PROGRAMMING
DESCRIPTION:
This MMC is much like MMC 722, Station Key Programming. The main
difference is that this MMC is system–wide rather than on a per–station basis.
Features are entered via the dial keypad by pressing numbers as shown in the
table. For example, for OHVA the number 6 is pressed three times. If the
BOSS key is required, press 2 twice for the first letter B, and then use the UP
or DOWN key to change selection from BARGE to BOSS.
DIAL KEYPAD
COUNT 1 2 3
DIAL 2 AAPLAY BARGE CALL
DIAL 3 DICT DICT FAUTO
DIAL 4 GPIK HDSET IOG
DIAL 5 LCR LCR LCR
DIAL 6 MMPA NEW OHVA
DIAL 7 PAGE REJECT SG
DIAL 8 TG UA VG
TYPE OF SET
0 24–BTN 3 6–BTN
1 12–BTN 5 48–BTN AOMs
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
ACTION DISPLAY
1. Press TRSF 723
Display shows
TYPE:24 BTN SETS
01:CALL1
→
2. Enter type of set via dial keypad (e.g.,5)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key
TYPE:48 BTN SETS
01:CALL1
→
3. Enter key number (e.g., 18)
OR
Press UP or DOWN key to make selection and
press RIGHT soft key
TYPE:48 BTN SETS
18:DS
→
To Next Page
Loading...
