SAMSUNG Programming
DCS-816 February, 1999
MMC 728 (Page 1 of 2)
MMC: 728 CLIP TRANSLATION TABLE
DESCRIPTION:
Allows the system administrator or technician to associate a CLIP number
received from the central office with a name programmed in this translation
table. If there is no match between a received number and a name in this table,
“no CLIP name” is displayed.
The translation table consists of 200 entries, each comprising a 16–digit
telephone number and a 16–digit name.
Names are written using the keypad. Each press of a key selects a character.
Pressing the dial pad key moves the cursor to the next position. For example, if
the directory name is “SAM SMITH,” press the number “ 7” four times to get the
letter “S.” Now press the number “ 2” once to get the letter “ A.” Continue
selecting characters from the table below to complete your message.
NOTE
When the character you want appears on the same dial pad key as the previous character, press
the UP key to move the cursor to the right.
COUNT
1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 Space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
Q
8
DIAL 9 W X Y Z 9
DIAL Q : = [ ]
Q
The # key can be used for the following special characters: #, space, &,
!, :, ?, ., %, $, –, <, >, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
To Next Page
Loading...
