Samsung DCS-816 - Page 217

SAMSUNG Programming
DCS-816 February, 1999
MMC 733 (Page 1 of 2)
MMC: 733 AA PLAN TABLE
DESCRIPTION:
Used to call up the customer recorded and pre–recorded messages into plans
compiled in MMC 732. Pre–recorded messages listed below can be applied
and destinations can be programmed as required. Specific ports are
programmed by MMC 735, AA Use Table.
There are a total of 64 messages on an AA card:
– 48 messages are to be recorded by the user (01–48),
– 16 messages are pre–recorded in ROM on the card (49–64).
Attributes are as follows:
ATTR TITLE DATA COMSG
0 DAY MSG 01–64 Introduction message during Day Mode
1 NIGHT MSG 01–64 Introduction message during Night Mode
2 ALTER MSG 01–64 Emergency message
3 INVLID MSG 01–64 Message when an invalid digit is dialled
4 NO ANS MSG 01–64 Message when there is no reply from the
destination
5 XFER MSG 01–64 Transfer notifying message
6 BUSY MSG 01–64 Message on busy reply
7 NO STN MSG 01–64 Message on retrial
8 NO ACT MSG 01–64 Message on no action
9 CAMP ON Yes/No Allow camp–on to busy extension
10 ANS DELAY 01–10 Answer Delay
11 RETRY CNT 0–5 No of times the AA will try to connect before
routing to final destination.
12 TRANS TABLE 01–12 Assigning associated TRANS TABLE
13 BUSY DEST DEST Alternative destination on busy
14 NO ANS DEST DEST Alternative destination on no answer
15 NO ACT DEST DEST Default destination on no action
16 INVALID DEST DEST Default destination on invalid action
There is a total of 12 tables (01–12) in the system, but not all tables have to
be used.
DESTINATION : STATION, STATION GROUP, AA PLAN NO.
ACTION DISPLAY
1. Press TRSF 733
Display shows
AA PLAN PROG(01)
DAY MSG : NONE
2. Dial AA PLAN TABLE number (01 – 12, e.g. 02)
OR
Press UP or DOWN to select and press RIGHT
soft key
AA PLAN PROG(02)
DAY MSG : NONE