Samsung DCS-816 - Page 99

SAMSUNG Programming
DCS-816 February, 1999
MMC 405 (Page 1 of 2)
MMC: 405 TRUNK NUMBER
DESCRIPTION:
Allows an 11–digit number to be entered to identify an individual trunk.
Numbers are written using the keypad. Each press of a key selects a digit.
Pressing the desired key moves the cursor to the next position. For example, if
the directory number is “ 426–4100,” press the number “4” five times to get the
number “ 4.” Now press the number “ 2” five times for number “ 2.” Continue
selecting characters from the table below to complete your number.
NOTE
When the number you want appears on the same dial pad key as the previous number, press the
UP key to move the cursor to the right or the DOWN key to move the cursor left. A space can be
entered by using these keys.
COUNT

1 2 3 4 5
DIAL 0 0 Q Z . )
DIAL 1 1 space ? , !
DIAL 2 2 A B C @
DIAL 3 3 D E F #
DIAL 4 4 G H I $
DIAL 5 5 J K L %
DIAL 6 6 M N O ^
DIAL 7 7 P R S &
DIAL 8 8 T U V
Q
DIAL 9 9 W X Y (
DIAL Q
Q
: = [ ]
THIS TABLE NEEDS TO BE CHECKED CAREFULLY
The # key can be used for special characters: #, space, &, !, :, ?, ., %, $, –, <, >, /,
=, [, ], @, ^, (, ), _, +, {, }, |, ;, \, " and ~.
PROGRAM KEYS
UP & DOWN Used to scroll through options/move cursor left or right
KEYPAD Used to enter selections
SOFT KEYS Move cursor left and right
SPK Used to store data and advance to next MMC
HOLD Used to clear previous entry
A Key 19, acts as toggle between upper case and lower case