Santec TSL-710 - Reads out the Current Sweep Condition; SX Reads out the Current Number of Completed Sweeps

Tunable Semiconductor Laser TSL-710
7-57
ST Syntax ST
 Description Issuesasoftwaretrigger.Thiscommandisusedasinstituteofan
   externaltrigger.SetthesweepmodefromSM7to12,andtrigger
   standbybeforeoperation.
Parameter None
Response None
 Example Startsasweep.
ST
SX Syntax SX
 Description Readsoutthecurrentnumberofcompletedsweeps.
Parameter None
 Response currentnumber
Example SX
→ 000100
    Indicatesthatthenumberofcompletedsweepsis100.
SK Syntax SK
 Description Readsoutthecurrentsweepcondition.
Parameter None
Response 0: Stop
1: Executing
2: Pause
   3:AwaitingTrigger
   4:Settingtosweepstartwavelength
    *Wheninstate“4”,sweepstop/pausecommandsarenotaccepted.
Example SK
→ 1
   Indicatesthatasweepisinoperation.
TRE Syntax TRE
 Description SetsEnableoftheexternaltriggersignalinput.
Parameter None
Response None
TRD Syntax TRD
 Description SetsDisableoftheexternaltriggersignalinput.
Parameter None
Response None