Santec TSL-710 - Re-Packing; Re-Packing and Shipping

Tunable Semiconductor Laser TSL-710
11-1
11
Re-packing and Shipping
CAUTION
Please make sure that the original shipping box is used during the shipment, according
to the following instructions. If the original shipping box is misplaced or damaged,
please contact our customer service department. We can arrange for the shipping box
to be sent to you.
Alternately, when the original shipping box is not available, send the instrument with a
sturdy, robust shipping box and at least 10cm packing material between the instrument
and the shipping box. The entire 10cm space on every side of the instrument should
be lled with a cushioning material.
The packing materials we used are designed to protect the instrument from
the shock or vibration during the shipment. If the instrument is shipped without
packing materials or improperly packed, the instrument might not be able
to maintain performance. Any instrument damage that occurred when the
instrument shipped without the original shipping box or without proper packing,
will not be applicable for warranty repair, even at the guaranteed term.
11-1 Re-packing
Special attention for re-packing and shipping is required when you ship the instrument
for repair or to a remote location.
Damage of the device may be caused by the vibration under transportation if the power
supply is not shut down properly. Make sure the power is shut down completely. (Refer
to 5-7)