Santec TSL-710 - SG Execute a Sweep

7-56
TSL-710 Operation Manual
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
Example SetsthesweepmodetoContinuousOne-wayoperation.
SM1
   Readsoutthecurrentlysetvalue.
SM
→ 00009
    IndicatesthatStepone-wayoperationisstartedbytriggersignal.
SG Syntax SG
 Description Executessweepsorputsthedeviceintriggersignalinputstandby.
   WhensweepmodeisSM1to6,executessweepsofnumberthat 
   speciedbySZ.
   WhensweepmodeisSM7to12,putsthedeviceintriggersignalinput 
   standby.
 Parameter None: Executesmultiplesweeps.
   1: Executesasweeponce.
Response None
 Example Executeasweep.
SG1
SP Syntax SP
 Description Pausesthesweep.
   Whenafastsweepspeedisset,pausewillnotfunction.
Parameter None
Response None
 Example Pausesthesweep.
SP
SQ Syntax SQ
 Description Stopsthesweep.
   Incontinuousoperationmode,thesweepiscontinuedtothestop 
   wavelength,andstop.Sendpausecommand“SP”andthensend“SQ”to
   stopasweepbeforereachingtheendwavelength.
Parameter None
Response None
 Example Stopsthesweep.
SQ
SR Syntax SR
 Description Resumesasweepfromthepausestate.
Parameter None
Response None
 Example Resumesasweep.
SR