Santec TSL-710 - Specific Command Set List (Command Set 2)

Tunable Semiconductor Laser TSL-710
7-47
■
7-4-2. TSL-710 Specic Command set List (Command set 2)
This Command set maintains compatibility with existing Santec products, though
does not satisfy the requirements specied in IEEE-488.2. Only Command set 2 is
available at control when using USB or RS-232C.
1. TSL-710 Specic command overview (Command set 2)
An overview of the specic commands available in Command set 2 is shown in the
following table.
Command Description Page
*IDN? Identication Query. Returns strings that identify the device. 7-49
LO Sets ON the LD. 7-49
LF Sets OFF the LD. 7-49
WA Sets / reads out the output wavelength. 7-49
FQ
Sets / reads out the output wavelength
in optical frequency.
7-49
FT Sets / reads out the ne-tuning. 7-50
FTF Stops Fine-tuning mode 7-50
OP Sets / reads out the optical output power in dBm. 7-50
LP Sets / reads out the optical output power in mW. 7-51
AF Switches to Auto for the power control. 7-51
AO Switches to Manual for the power control. 7-51
AT Sets / reads out the attenuator value. 7-51
SC Sets Close status of the internal shutter. 7-51
SO Sets Open/ status of the internal shutter. 7-52
PR Revises the compensate power data of sweeps in auto power mode. 7-52
SS Sets / reads out the sweep start wavelength. 7-52
FS Sets / reads out the sweep start frequency. 7-52
SE Sets / reads out the sweep end wavelength. 7-53
FF Sets / reads out the sweep end frequency. 7-53
SA
Sets / reads out the wait time between each sweep
in continuous sweep operation.
7-53
SB
Sets / reads out the amount of time spent during
each step in step sweep operation.
7-54
SZ Sets / reads out the number of wavelength sweeps. 7-54
SN Sets / reads out the speed for continuous sweep. 7-54
WW
Sets / reads out the step interval (wavelength) of
step sweeps.
7-55
Specic Command List (Command set 2 Group)