Santec TSL-710 - Page 100

7-46
TSL-710 Operation Manual
6. Command error
Errors issued in Command set 1 are stored as error messages in the error
queue and can be read out with the ”:SYSTem:ERRor?” command. The list is
as shown below.
Code Error message
0 No error
-102
Syntax error
-103 Invalid separator
-108 Parameter not allowed
-109 Missing parameter
-113 Undened header
-148 Character data not allowed
-200 Execution error
-222 Data out of range
-410 Query INTERRUPTED
Command Error List (Command set 1 Group)
[:SOURce]:AM:STATe?
Syntax [:SOURce]:AM:STATe?
Description Reads out status of amplitude modulation of the laser output.
Parameter None
Response 0:Disable
1:Enable
Example :AM:STAT?
→1
Indicates that the amplitude modulation is enabled.