Santec TSL-710 - Page 99

Tunable Semiconductor Laser TSL-710
7-45
[:SOURce]:WAVelength:SWEep:SOFTtrigger
Syntax [:SOURce]:WAVelength:SWEep:SOFTtrigger
Description Issues a soft trigger. Executes sweep from trigger
standby mode.
Parameter None
Response None
Example : WAV:SWE:SOFT
Issues a soft trigger.
[:SOURce]:READout:POINts?
Syntax [:SOURce]:READout:POINts?
Description Reads the number of data points recorded by
wavelength logging.
Parameter None
Response 0 〜 65535 (Returned with a 5-digit integer)
[:SOURce]:READout:DATa?
Syntax [:SOURce]:READout:DATa?
Description Reads all the data recorded by wavelength logging.
The data is comprised of a header (ASCII characters)
and wavelength data array (4-byte binary).
Parameter None
Response Ex.: #42000
□□□□□□□□ .......
The “4” after the “#” indicates the number of digits
following “4”. The following four digits, “2000”, indicate
the amount of recorded data in byte units. In this
example, there are 2000 bytes of data (500 points).
The data is saved in integer format in 0.1 pm units.
Binary data is transmitted in Intel byte order.
[:SOURce]:AM:STATe
Syntax [:SOURce]:AM:STATe<wsp><value>
Description Enables and disables amplitude modulation of the
laser output.
External modulation setting cannot be changed to
enable, when coherence control is On.
Parameter 0: Disable
1: Enable
Response None
Example :AM:STAT 1
Enables the amplitude modulation of the laser output.