Santec TSL-710 - Command Reference

7-16
TSL-710 Operation Manual
Two kinds of command sets are provided for the TSL-710. Select one of them in
advance and use the commands in that category. Commands in one command set
cannot be used with commands in the other command set simultaneously.
Command set 1
This command set complies with IEEE-488.2, and is available only in GPIB
communication. Set the command setting for GPIB to “SCPI” to make the
command set available.
Command set 2
Santec’s original existing command set.
・In GPIB communication, set the command setting to “Santec” to make the
command set available.
・ Use this command set for USB or RS-232C communication.
7- 4 Command Reference
■
7-3-5. Command
Only Command set 2 can be used. Refer to “7-4-2. TSL-710 Specic Command List
(Command set 2)”.