Tunable Semiconductor Laser TSL- 710
5-3
Make sure that the optical fiber is connected correctly to the optical output
connector before performing LD output.
Also, be careful that high power light does not enter the optical output connector
from the outside of the product. If light exceeding 100 mW enters the optical
output connector, internal equipment may be damaged.
5 -2 LD Output
After turning the power on or the LD output off, we recommend that you wait at
least 30 seconds before turning on LD output. Operation of the keys on the front
panel and operation by communication command are not possible while the LD
ON indicator LED is blinking.
CAUTION
1. Press the LD ON/OFF key. The LED turns green and the current is fed to the LD.
The light intensity is set to the intensity just before LD output is turned off.
It takes from 1 to 2 minutes to turn on LD output. During this period, the LD
ON indicator LED blinks, and “TempCtrl” is displayed on the main screen. Light
is output from the optical output connector after the LED status switches from
blinking to illuminated.
Analog Output Analog Input
LF Mod. RF Mod.
LD ON/OFF Key
LD ON LED
Optical Output Connecor
To Next Page
Loading...
