7-48
TSL-710 Operation Manual
Command Description Page
WF
Sets / reads out the step interval (frequency) of
step sweeps.
7-55
SM Sets the sweep operation mode. 7-55
SG Execute a sweep. 7-56
SP Pause the sweep. 7-56
SQ Stop the sweep. 7-56
SR Resume the sweep from pause state. 7-56
ST Issues a soft trigger. 7-57
SX Reads out the current number of completed sweeps. 7-57
SK Reads out the current sweep condition 7-57
TRE Sets Enable of the external trigger signal input. 7-57
TRD Sets Disable of the external trigger signal input. 7-57
TM Sets the timing of the trigger signal output. 7-58
TW Sets / reads out the interval of the trigger signal output. 7-58
CO Turns ON the coherence control. 7-58
CF Turns OFF the coherence control. 7-58
GA Sets / reads out the GPIB address. 7-58
GD
Sets / reads out the command delimiter for
GPIB communication.
7-59
BL Sets / reads out the speed of serial communication. 7-59
SD
Sets / reads out the command delimiter for
serial communication.
7-59
SU Reads out the status. 7-60
TN
Reads the number of data points recorded by wavelength
logging.
7-61
TD
Reads the data recorded by wavelength logging one data
record at a time. The data is returned in ASCII characters.
7-61
TA
Reads all the data recorded by wavelength logging.
The data is in 4-byte binary format (Intel byte order).
7-61
HFE Turns the status of external modulation bandwidth broader. 7-62
HFD Turns the status of external modulation bandwidth narrower. 7-62
WAS Registers a wavelength data to the memory area. 7-62
WAM Recalls the wavelength data from the memory area. 7-62
WAR Reads out wavelength data registered in the memory. 7-62
To Next Page
Loading...
