Santec TSL-710 - Page 109

Tunable Semiconductor Laser TSL-710
7-55
WW Syntax WW<value>
 Description Setsthestepinterval(wavelength)ofstepsweeps.
   Whenparameterisnotspecied,readsoutthecurrentlysetvalue.
 Parameter Range: 0.0001~160(nm)
   Step: 0.0001(nm)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthestepintervalto1nm.
WW1
   Readsoutthecurrentlysetvalue.
WW
→010.000
    Indicatesthatthestepintervalis10nm.
WF Syntax WF<value>
 Description Setsthestepinterval(frequency)ofstepsweeps.Whenparameterisnot
   specied,readsoutthecurrentlysetvalue.
 Parameter Range: 0.00002~19.76219(THz)
   Step: 0.00001(THz)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthestepinterval(frequency)to0.1THz.
    WF0.1
   Readsoutthecurrentlysetvalue.
WF
→00.1000
    Indicatesthatthestepinterval(frequency)is0.1THz.
SM Syntax SM<value>
 Description Setsthesweepoperationmode.Whenparameterisnotspecied,reads
   outthecurrentlysetvalue.
 Parameter 1:Continuousoperation,One-way
   2:Continuousoperation,Two-way
   3:Stepoperation,One-way
   4:Stepoperation,Two-way
   5:Stepoperation,One-way(constantfrequencyinterval)
   6:Stepoperation,Two-way(constantfrequencyinterval)
   7:Continuousoperation,One-way.Operationisstartedbytriggersignal.
   8:Continuousoperation,Two-way.Operationisstartedbytriggersignal.
   9:Stepoperation,One-way.Operationisstartedbytriggersignal.
   10:Stepoperation,Two-way.Operationisstartedbytriggersignal.
   11:Stepoperation,One-way(constantfrequencyinterval).Operationis
   startedbytriggersignal.
   12:Stepoperation,Two-way(constantfrequencyinterval).Operationis 
   startedbytriggersignal.