Santec TSL-710 - Page 108

7-54
TSL-710 Operation Manual
SB Syntax SB<value>
 Description Setstheamountoftimespentduringeachstepinstepsweepoperation.
   Thewaittimebetweeneachsweepisalsosettothesamevalue.This
   waittimedoesnotincludethetimerequiredforwavelengthconversion.
   Whenparameterisnotspecied,readsoutthecurrentlysetvalue.
 Parameter Range:0~999.9(s)
   Step: 0.1(s)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthewaittimeofeachstepto1second.
SB1
   Readsoutthecurrentlysetvalue.
SB
→0000.50
    Indicatesthatthecurrentlysetwaittimeofeachstepis0.5 
    second.
SZ Syntax SZ<value>
 Description Setsthenumberofwavelengthsweeps.Whenparameterisnotspecied,
   readsoutthecurrentlysetvalue.
Parameter Range: 0 ~999
Step: 1
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthenumberofsweepsto100.
SZ100
   Readsoutthecurrentlysetvalue.
SZ
→ 000100
    Indicatesthatthenumberofsweepsissetto100.
SN Syntax SN<value>
 Description Setsthespeedforcontinuoussweep.Whenparameterisnotspecied,
   readsoutthecurrentlysetvalue.
 Parameter Range: 0.5~100(nm/s)
   Step: 0.1(nm/s)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthespeedforcontinuoussweepto100nm/s.
SN100
   Readsoutthecurrentlysetvalue.
SN
→100.000
    Indicatesthatthesweepspeedissetto100nm/s.