Santec TSL-710 - Page 107

Tunable Semiconductor Laser TSL-710
7-53
SE Syntax SE<value>
 Description Setsthesweepstopwavelength.Whenparameterisnotspecied,reads
   outthecurrentlysetvalue.
 Parameter Range: MinimumsettingwavelengthtoMaximum(nm)
   Step: 0.0001(nm)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthesweepstopwavelengthto1630nm.
    SE1630
   Readsoutthecurrentlysetvalue.
SE
→1560.000
    Indicatesthatthecurrentlysetstopwavelengthis1560nm.
FF Syntax FF<value>
 Description Setsthesweepstopfrequency.Whenparameterisnotspecied,reads
   outthecurrentlysetvalue.
 Parameter Range: MinimumsettingfrequencytoMaximum(THz)
   Step: 0.00001(THz)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthesweepstopfrequencyto199.8616THz.
    FF199.8616
   Readsoutthecurrentlysetvalue.
FF
→199.8616
    Indicatesthatthecurrentlysetstopfrequencyis199.8616THz.
SA Syntax SA<value>
 Description Setsthewaittimebetweeneachsweepincontinuoussweepoperation.
   Whenparameterisnotspecied,readsoutthecurrentlysetvalue.
 Parameter Range:0~999.9(s)
   Step: 0.1(s)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthewaittimebetweeneachsweepto1second.
SA1
   Readsoutthecurrentlysetvalue.
SA
→0000.50
    Indicatesthatthecurrentlysetwaittimeis0.5second.