Santec TSL-710 - Page 106

7-52
TSL-710 Operation Manual
SO Syntax SO
 Description SetsOPENstatusoftheinternalshutter.
Parameter None
Response None
PR Syntax PR
 Description Revisesthecompensatepowerdataofsweepsinautopowermode.
   Recommendexecutingthiscommandwhen"OverLD"or"LowPwr"
   isdisplayed.
Parameter None
Response None
SS Syntax SS<value>
 Description Setsthesweepstartwavelength.Whenparameterisnotspecied,reads
   outthecurrentlysetvalue.
 Parameter Range: MinimumsettingwavelengthtoMaximum(nm)
   Step: 0.0001(nm)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthesweepstartwavelengthto1510nm.
    SS1510
   Readsoutthecurrentlysetvalue.
SS
→1560.000
    Indicatesthatthecurrentlysetstartwavelengthis1560nm.
FS Syntax FS<value>
 Description Setsthesweepstartfrequency.Whenparameterisnotspecied,reads
   outthecurrentlysetvalue.
 Parameter Range: MinimumsettingfrequencytoMaximum(THz)
   Step: 0.00001(THz)
 Response Currentlysetvalue.Avalueisreturnedbothonsettingandonreading.
 Example Setsthesweepstartfrequencyto199.8616THz.
    FS199.8616
   Readsoutthecurrentlysetvalue.
FS
→199.8616
    Indicatesthatthecurrentlysetstartfrequencyis199.8616THz.